出口外墙腻子粉价格 阿曼苏丹国腻子粉供货商 腻子粉价格 防水腻子粉

Putty powder is essential in home decoration. Putty powder is mainly used for wall pretreatment, laying a good foundation for achieving uniform and smooth paint. Usually, we seldom see the brand advertisement of putty powder in the media. So when we choose putty powder, we will be confused. I don't know which brand of putty powder is good.
Decoration wall powder, the preferred Yao Wang Bang!
Instructions for the Use of Putty Powder
Yao Wang Bang putty powder is a kind of building decoration material. Its main ingredients are heavy calcium, grey calcium, cement as cementitious material and a natural environmental cellulose ether as a substitute for glue. Usually the whiteness of putty is above 85 and the fineness is above 330. Putty is a kind of base material for wall repair and leveling, which lays a good foundation for the next decoration (painting and wallpaper). Yao Wang Bang environmental protection putty powder is produced according to the current standard of our country: JG/T 298-2010 GB 18582-2008.
Product characteristics:
1. It can be used without glue directly mixed with water.
2. Compared with the traditional stone powder and glue batch wall, this product has the advantages of formaldehyde-free, easy construction, strong bonding force, no cracking, no powder removal, and fine and smooth surface.
3. Green environmental protection, non-toxic and non-irritating odor, non-radioactive;
4. Moisture-proof and mildew-proof, the longer the harder, not affected by climate.
Construction requirements:
1. Make the wall smooth. If there is oil, dirt, dust or other loose rubber on the wall, it must be cleaned up before construction.
2. This product is mixed with about 2 parts of powder: 1 part of water (first water and then powder). It is better to use after 10 minutes.
3. The construction operation is basically the same as that of the traditional stone powder glue batch wall construction. Generally speaking, it should be done once for each time according to the bottom cover, not too thick, 1-2mm is appropriate. When the first time is done, it should be flat and thin as possible, and then cover after the bottom is completely dried, the effect is better. About 78% of the dry surface paste is polished 2-3 times with a scraper after the cover is flattened. The effect can not be achieved until the paste is dry. Otherwise, the effect will be affected.
Matters needing attention:
1. This product can't add auxiliary materials (such as glue, white latex, cooked rubber powder, etc.) at will. If the quality problems are caused by the addition, our factory is not responsible for them.)
2. This product can not be directly batched on gypsum board, silicate board, splint, cement board and other non-gray sand walls.
3. The product is stored in a cool and dry place with a shelf life of one year. If no caking or deterioration occurs after the shelf life, it can be used continuously without affecting the quality.
4. When renovating old indoor walls, small pieces of experiments should be done on the walls first. If there is a yellowing phenomenon, it is not suitable to use.