飞盈佳乐80a水上滑板电调5-12s飞龙系列水上冲浪板动力
深圳市飞盈佳乐电子有限公司
  • 所在区域:广东深圳宝安区
  • 经营性质:
  • 企业类型:
  • 注册地:
  • 主营产品:三相无刷电子调速器,遥控模型电调,无刷马达控制系统
  • 注册资金:
  • 企业已认证
  • 个人实名已认证
    商家产品分类
    “飞盈佳乐80a水上滑板电调5-12s飞龙系列水上冲浪板动力”详细信息
产品规格: B-FW080012-C2A1-01 产品数量: 1.00 台
包装说明: 不限 价格说明: 不限
查看人数: 293 人 本页链接: https://info.b2b168.com/s168-159952828.html
型号: 80A 材质: 金属
用途: 电机控制器 配件类型: 仪器
等级: 适用领域: 无刷电机
是否跨境货源: 品牌: 飞盈佳乐
产品规格: 22V-50V 产品类型: 动力系统


深圳市飞盈佳乐电子有限公司

双向 无刷电子调速器
说明书
ATTENTION
● 电调采用功能强大STM32F051系列MCU,ARM 32位 Cortex内核,工作频率48MHz;
● 专门优化的正反向运行的程序,兼容性非常出色;
● *设置任何参数,使用较为简单;
● 全铝合金外壳,显着提高散热能力;
● 防水,尤其适合水下推进器的使用;
● 高可支持刷新率高达500Hz的油门信号(注:>=500Hz的油门信号皆为非标准油门信号);
● 高支持14S锂电池,支持单节锂电池电压4.35V。
持续电流80A
(散热良好)
瞬时电流120A(10S)
NO:BEC 尺寸(供参考) 重量(供参考) 锂电池节数 型号
Magellan-WP  5-14S 215g  86.6x37.8x26mm
(声音次数>=5次后用一长鸣音”Beeeep--”表示5)
1.正常工作模式
● 启动保护:当加大油门时,三秒内未能正常启动马达,电调将会关闭动力输出,油门摇杆需再次置于低点后才可以重新启动马达。出现这种情况的原因
可能有:电调和马 达连线接触不良或有断开、螺旋桨被其他物体阻挡等)
● 运行堵转保护:在运行过程中电机、螺旋桨被其他物体阻挡等时,电调将会关闭动力输出,油门摇杆需再次置于零点后才可以重新启动马达。
● 油门信号丢失保护:在运行过程中,当电调检测到油门遥控信号丢失0.3 秒以上时立即关闭输出,以免因螺旋桨继续高速转动而造成更大的损失。信号恢
复后,电调也随即恢复相应的功率输出。
● 温度保护:电调温度**过100℃时,电调将降低输出功率;温度保护后,电调温度降低至80℃以下时恢复正常功率输出。
开启遥控器,将油门摇杆置于中点位置
电调接上电池,等待1S后,马达发出N声鸣叫声,表示电池
节数。此时表明电调已经准备就绪。
感谢您使用本产品!本产品功率强大,错误的使用可能导致人身伤害和设备损坏,强烈建议您在使用设备前仔细
阅读本说明书并保存,严格遵守规定的操作程序。我们不承担因使用本产品或擅自对产品进行改造所引起的任何
责任,包括但不限于对附带损失或间接损失的赔偿责任。我们有权在不经通知的情况下变更产品的设计、外观、
性能及使用要求。
● 合理的使用电调可延长使用寿命,在使用过一定时间后,请清理电调上的水渍,污渍,避免电调短路。
● 如在水下使用此ESC时,请根据自身产品的结构尽可能进行额外的防水处理,尤其是所有的接插件、焊接位置等……。
● 请不要**出ESC工作电流范围使用,避免产品过载使用损坏。
● 如需更多信息,请联系飞盈佳乐售后或者技术支持。
01 主要特性
02 产品规格
03 连线示意图
04 尺寸示意图
07 常见故障及提示音
08 注意事项
06 保护功能
05 正常工作模式
故障现象 警报音 可能原因
上电后马达无法启动
上电后马达无法启动
“哔哔哔哔”的急促短音
无
油门未归零
接收机油门通道无油门信号输出
将油门打至零点
检查发射机与接收机配合是否正常;检查油门控
制通道接线是否正常
解决办法
“哔、哔、哔、......”(每个间隔1秒) 运行中马达停转 油门信号输出丢失 检查信号线是否松动或者脱落
上电后马达无法启动 “哔哔......”(每个间隔2秒) 电池电压**限
检查电池电压;
更换符合电调工作电压的电池
正向大:2000us
中点(零点):1500us
反向大:1000us
正反转油门行程范围
W P W P
ST
32
WP
ATTENTION
BEC
80A 120A 5-14S 215g No 86.6x37.8x26mm
01 Main features
02 Specification
03 Connection diagram
04 Dimensions
07 Trouble shooting
08 Attention
06 Protections
05 Normal start-up User Manual
Bidirectional Brushless ESC
Thank you for using our product. Any Improper operation may cause personal injury damage to the
product and related equipments. This high power system for RC model can be dangerous ,we strongly
recommend reading the user manual carefully and completely. We will not assume any responsibility for any
losses caused by unauthorized modifications to our product. We have the right to change the design,
appearance, performance and usage requirements of the product without notice.
● ESC use STM32F051 MCU, ARM 32-bit Cortex Core with 48 MHz frequency.
●  Specially optimized firmware for forward and reverse operation , excellent compatibility.
● It is easy to use without setting any parameters.
● Aluminum cover, significantly improving heat dissipation.
●  proof Sea Scooter Water , especially suitable for  ;
● Supports frequency of throttle ** to 500Hz max . ( ≥500Hz throttle ** is nonstandard ** )
● Maximum supports 14S LiPo battery, supports for single LiPo battery voltage up to 4.35V.
Con. Current
( be well-cooled )
Burst Current
(10S)
Size
(for reference)
Weight
(for reference)
LiPo cells Model
1.Normal start-up
Turn on the transmitter, move the
throttle stick to the neutral position
Connect ESC & battery packs, wait for 1 seconds, the motor
emits N sounds, which indicates the battery cells. then ESC is
ready for working.
● Start-up Protection: ESC will cut off output if it fails to start the motor within 3 seconds by accelerating throttle. you need to move the throttle stick
back to the bottom position and restart the motor.( The possible causes : Bad connection or disconnection between ESC & motor , propellers are
blocked, etc)
,it will cut off power or output immediately . ESC will  ● Stall Protection: When the motor and propeller are blocked by other objects during operation
resume the corresponding output after the throttle stick back to the neutral position.
● Throttle Signal Loss Protection: ESC detects the loss of throttle ** for over 0.3 seconds during operation , it will cut off power or output
immediately to avoid an even greater loss caused by the continuous high speed rotation of propellers. ESC will resume the corresponding output
after the normal ** is restored.
● Over heating protection: When the temperature of ESC exceeds 100 ℃, the output power will be reduced; The normal power output will be
restored when the temperature of ESC is lower than 80 ℃.
251400-1131, V1.0
● Reasonable use of ESC can prolong the service life. please clean up the water and stains on the ESC after a certain period of time , to 
avoid electric short circuit.
● If the ESC is used underwater, additional waterproof treatment should be carried out according to the structure of your product,
especially all connectors, welding positions, etc.
● Please do not exceed the working current of ESC to avoid overload and damage .
● Please contact Flycolor sales or technical support for more information.
Forward Max :2000us
Neutral position :1500us
Reverse Max :1000us
Birdirection throttle range
( When motor emits tone times ≥5 times, long " Beep--" will represent 5 times)
Trouble
ESC was unable to
start the motor
ESC was unable to
start the motor
“Beep beep beep…”
Urgent short tone
Warning Tone
“Beep…”
Time interval is 1 second
Possible Cause
The throttle stick is not at the neutral
position or throttle range is too small.
No output ** from the throttle
channel on the receiver.
ESC was unable to
start the motor
Solution
Move the throttle stick to the neutral position.
Check whether the ** wire is loose or falling off.
The motor stops
running during
operation
Battery voltage over limit
“Beep,beep,…”
Time interval is 2 seconds
Check the battery voltage; Replace the battery that
meets the working voltage of ESC.
Loss of throttle ** output.
Check whether the communication between
transmitter and receiver is normal; Check whether
the wiring of throttle control channel is normal.
No
Magellan-WP 80A
W P W P
ST
32
WP

欢迎来到深圳市飞盈佳乐电子有限公司网站,我公司位于经济发达,交通发达,人口密集的中国经济中心城市—深圳。 具体地址是广东深圳宝安区72区甲岸工业园,联系人是刘春荣。
主要经营飞盈佳乐(FLYCOLOR)成立于2009年,在永磁无刷电机智能控制技术方面达到了行业成员之一水平, 公司从事电机智能控制产品的研发、生产、销售,产品包括农业植保机电调、FPV穿越机电调、航空模型电调、遥控车模电调、遥控船模电调、 电动工具控制器、交通工具控制器以及无刷电机综合检测仪、噪音检测仪等。。
单位注册资金未知。

    我要给“飞盈佳乐80a水上滑板电调5-12s飞龙系列水上冲浪板动力”留言
    “飞盈佳乐80a水上滑板电调5-12s飞龙系列水上冲浪板动力”联系方式

    深圳市飞盈佳乐电子有限公司

  • 刘春荣(销售)

    手机:13510858512

    地址:广东深圳宝安区72区甲岸工业园

    网址:http://fly1234567a.b2b168.com/

相关分类: 卫星模型 玩具枪刀 玩具乐器 特殊/专业模型玩具 气模 拼装模型 模型制作公司 模型配件 军事模型 建筑模型 火车模型 **模型 过家家玩具 飞机模型 仿真模型 动物模型 动漫模型 船模 车模

相关地区: 深圳光明区 深圳坪山区 深圳龙华区 深圳罗湖区 深圳福田区 深圳南山区 深圳宝安区 深圳龙岗区 深圳盐田区

关于八方 | 关于我们 | 八方币招商合作网站地图 | 免费注册商业广告 | 一元广告 | 友情链接 | 联系我们 | 八方业务| 汇款方式商务洽谈室投诉举报
粤ICP备10089450号 - Copyright © 2004 - 2024 b2b168.com All Rights Reserved