产品规格: | 不限 | 产品数量: | 不限 |
---|---|---|---|
包装说明: | 按订单 | 价格说明: | 不限 |
查看人数: | 145 人 | 本页链接: | https://info.b2b168.com/s168-83409108.html |
气动单工位烫画机
全新的结构设计
流线型高档外观设计,新造型精巧轻便,机器外形更美观。
新款烫标机带有计数器,气动烫画机,方便您统计数据有利于工厂流水线大量生产。
Pneumatic single position stamping machine
New structural design
Streamlined and upscale appearance design, the new shape is exquisite and portable, the machine shape is more beautiful.
The new scalding machine has a counter,热转印烫画机, which makes it convenient for you to count the data in favor of mass production of the factory assembly line.
四工位维修主要事项:
1、压力不够均匀,这种情况下需先用尺来测量发热板四边离底板四边距离是否一致,若不一致,可调下发热板中心的四务丝杆“下”螺母,烫画机,向下调紧发热板升高,向“上”调紧发热板降低。
2、压力太大或是太小。则须调节过滤器上的调节阀,往上提“+”方向为增加压力;往下压“-”为减少压力。
Main maintenance matters:
1, pressure is not uniform, this case need to use a ruler to measure heat plate edges distance from bottom edges are consistent, if inconsistent, adjustable heating plate under the center of the four services screw nut 'under', cut close to the heating plate increases, to the 'on' tighten lower heating plate.
Too much pressure or too little. Adjust the conitrol valve on the filter and raise the '+' to increase the pressure. Press down '-' to reduce stress.